Note that these commands will create a backup copy of the JTAG server ( jtagd.bak). If you have a doubt, it won't harm to patch both files.īefore executing the commands, replace by your installation path (e.g., /opt/altera/10.0). Select the set corresponding to your system. There are 2 sets of commands, one for 32-bit OS and the other one for 64-bit. Now we will use sed to replace the paths that the JTAG server is looking at. This soft link will disappear on reboot, so if you don't want to type it every time, add this line in a script or in your /etc/rc.local file (without the sudo). Sudo ln -s /sys/kernel/debug/usb/devices /dev/bus/usb/devices It is generally found in C:\altera\="6001", MODE="0666"įor older Quartus versions than 11.0, we need to patch the JTAG server to look for devices in /sys/kernel/debug/usb/devices instead of /proc/bus/usb/devices, and in /dev/bus/usb/././ instead of /proc/bus/usb/././.Īs the former won't fit in the string placeholder of the binary file, we choose to create a soft link. Select the usb-blaster folder from your Quartus install. Windows should ask you for the location of the drivers. If you are updating a previous version of Quartus II, do not forget to update the USB-Blaster driver accordingly or you may experience strange behavior from JTAG based features. But before being able to program the board you will need to install the drivers. (No need to open the subscription page request). At the end of the installer you can run Quartus II.Note that it is possible to add more components later on.ModelSim-Altera Starter edition (Free).Execute the installer and follow the instructions until you reach Components Select.Then you can Enable Optimization again for future runs.Go to the Download page of the Quartus II Web Edition here and download it. If you are loading an old project and compiled all files and simulations still don't come up, you may need to disable the optimizaion option on the simulation setup and then execute. You need to compile the following:Ģ20model.vhd, 220pack.vhd into lpm libraryĪltera_mf_components.vhd, altera_mf.vhd, altera_primitives.vhd into alteraĪfter you compile these once, you may change them to "do not compile". The source files for Altera models are located in: altera/10.0/quartus/eda/sim_lib/. When installing or upgrading Modelsim, one has to recreate libraries as follows: The solution is add the following line to either modelsim.ini (or project.mpf): After contacting Mentor Graphics, it turns out that the path to some directories were previously hardcoded and not anymore. When loading my mpf file from older ModelSim revisions into v6.6c, any compile would fail with error message: Error: library std not found.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |